xTool P3 80W CO2

In this xtool p3 80w co2 review, the xTool P3 ranks fifth of ten in our 2026 guide and carries the label best for large-format production cutting. It is an 80W CO2 laser cutter that sells for $6,299 and holds a 4.5 rating from 22 Amazon ratings. Its 36 by 18 inch workspace and 1,200mm/s top speed put it in a different class than the desktop diode machines around it. In practice, this is a machine for a shop that cuts panels all day, not for a hobbyist in a spare room.

The headline number is the 80W CO2 tube, which cuts 20mm wood and 25mm acrylic in one pass rather than several. The automation handles the setup work: LiDAR ranging sets autofocus on its own, and dual HD cameras (a 16MP SkyView plus a close-range detail camera) hold alignment to 0.0079 inch. On top of that, the AutoLift base rises up to 8.7 inches, so tall blanks and curved parts fit without a jig. For a production run, Smart Nesting matters most, since it reaches 98.7% material utilization and trims waste on every sheet. Meanwhile, Variable Batch Fill with spreadsheet import lets one file carry hundreds of personalized pieces. The Class 1 enclosure adds lid interlocks plus active detection and suppression.

At $6,299, the xTool P3 is the most expensive laser engraver in our top ten, so value depends on throughput. By contrast, cheaper picks in the guide cost far less but cut thinner stock and slower. Even so, 363 pounds and a 49.21 by 30.71 inch footprint rule out apartments and small garages, and the 22 Amazon ratings mean long-term reliability data is still thin. The 12 month warranty covers the first year only. However, if your jobs are large panels and repeat batches, the speed and nesting savings pay the difference back. If you cut small gifts on weekends, start with a smaller diode or the S1 instead.